<div dir="ltr">Hi,<div><br></div><div>Last time I asked about routing issue on a wifi connected machine.</div><div>Today I have noticed that this happens also on my *wired* machine.</div><div><br></div><div>My resolv.conf file is 2 lines to the router: nameserver 192.168.1.1 and to Netvision (194.90.1.5)</div>
<div><br></div><div>My routing is very simple one:</div><div><br></div><div><div>$ /sbin/route</div><div>Kernel IP routing table</div><div>Destination Gateway Genmask Flags Metric Ref Use Iface</div>
<div>192.168.1.0 * 255.255.255.0 U 0 0 0 eth0</div><div>169.254.0.0 * 255.255.0.0 U 0 0 0 eth0</div><div>default 192.168.1.1 0.0.0.0 UG 0 0 0 eth0</div>
<div><br></div></div><div>The weird part? running the "route" (without any parameters) shows me the routing correctly if I run the "route" command 6-7 times over, but in the 8th time (more or less) I see the IP's, then it wait 2-4 seconds and then it shows the "default" line. <br clear="all">
<br></div><div>I really don't have any explanation for it. I even tried to remove the resolv.conf, and it had no impact at all.</div><div><br></div><div>Suggestions?</div><div><br></div><div>Thanks,</div><div>Hetz<br>
-- <br>my blog (hebrew): <a href="http://benhamo.org">http://benhamo.org</a><br>Skype: heunique<br>MSN: <a href="mailto:hetz-blog@benhamo.org">hetz-blog@benhamo.org</a><br>
</div></div>