Arduino on Mageia linux

[Shlomo Solomon]

As I already wrote, it turned out to be a bad USB cable. I should have
checked that first. My bad.

On Thu, 22 Jun 2017 15:20:40 +0300
borissh1983 at gmail.com wrote:

> Hi , 
> 
> I had a similar issue when I checked the wrong board in the IDE (few
> years ago things may have changed). 
> 
> Unplug the device , close the IDE , plug it in again and : 
> 
> dmesg
> ls /dev/serial/by-*
> 
> start the IDE again and make sure you choose the correct board. 
> 
> On Tuesday, 20 June 2017 13:32:28 IDT Shlomo Solomon wrote:
> > I installed the Arduino IDE from Mageia RPMs and added my user to
> > the lock group as instructed.
> > 
> > In the tools >> serial port menu, there is no  /dev/ttyUSB0 -
> > only /dev/ttyS0 and  /dev/ttyS1. I tried both of them but could not
> > upload a program. I read that sometimes Arduino needs to be run as
> > root, so I tried that too with no success. Here's what I get when I
> > try to upload:
> > 
> > Binary sketch size: 1,056 bytes (of a 32,256 byte maximum)
> > Binary sketch size: 1,056 bytes (of a 32,256 byte maximum)
> > avrdude: stk500_recv(): programmer is not responding
> > avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
> > avrdude: stk500_recv(): programmer is not responding
> > avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x00
> > avrdude: stk500_recv(): programmer is not responding
> 
> 



-- 
Shlomo Solomon
http://the-solomons.net
Sent by Claws Mail 3.11.1 - KDE 4.14.5 - LINUX Mageia 5