The *route* saga continues, weirder...

[Hetz Ben Hamo]

Hi,

Last time I asked about routing issue on a wifi connected machine.
Today I have noticed that this happens also on my *wired* machine.

My resolv.conf file is 2 lines to the router: nameserver 192.168.1.1 and to
Netvision (194.90.1.5)

My routing is very simple one:

$ /sbin/route
Kernel IP routing table
Destination     Gateway         Genmask         Flags Metric Ref    Use
Iface
192.168.1.0     *               255.255.255.0   U     0      0        0 eth0
169.254.0.0     *               255.255.0.0     U     0      0        0 eth0
default         192.168.1.1     0.0.0.0         UG    0      0        0 eth0

The weird part? running the "route" (without any parameters) shows me the
routing correctly if I run the "route" command 6-7 times over, but in the
8th time (more or less) I see the IP's, then it wait 2-4 seconds and then it
shows the "default" line.

I really don't have any explanation for it. I even tried to remove the
resolv.conf, and it had no impact at all.

Suggestions?

Thanks,
Hetz
-- 
my blog (hebrew): http://benhamo.org
Skype: heunique
MSN: hetz-blog at benhamo.org
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mailman.cs.huji.ac.il/pipermail/linux-il/attachments/20100103/b5655473/attachment.html>