Arduino on Mageia linux

[Shlomo Solomon]

Sorry - just noticed I cut off part of the error message, so here it is
again:

WARNING:  RXTX Version mismatch
        Jar version = RXTX-2.2
        native lib Version = RXTX-2.2pre2
Binary sketch size: 1,056 bytes (of a 32,256 byte maximum)
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
avrdude: stk500_recv(): programmer is not responding
avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x00





On Tue, 20 Jun 2017 13:32:28 +0300
Shlomo Solomon <shlomo at the-solomons.net> wrote:

> I installed the Arduino IDE from Mageia RPMs and added my user to the
> lock group as instructed.
> 
> In the tools >> serial port menu, there is no  /dev/ttyUSB0 -
> only /dev/ttyS0 and  /dev/ttyS1. I tried both of them but could not
> upload a program. I read that sometimes Arduino needs to be run as
> root, so I tried that too with no success. Here's what I get when I
> try to upload:
> 
> Binary sketch size: 1,056 bytes (of a 32,256 byte maximum)
> Binary sketch size: 1,056 bytes (of a 32,256 byte maximum)
> avrdude: stk500_recv(): programmer is not responding
> avrdude: stk500_getsync() attempt 1 of 10: not in sync: resp=0x00
> avrdude: stk500_recv(): programmer is not responding
> avrdude: stk500_getsync() attempt 2 of 10: not in sync: resp=0x00
> avrdude: stk500_recv(): programmer is not responding
> 
> 
> 



-- 
Shlomo Solomon
http://the-solomons.net
Sent by Claws Mail 3.11.1 - KDE 4.14.5 - LINUX Mageia 5